Ball Joints and Upper Control Arm 2004 Ford F150
I had my truck in the shop a few weeks ago for some unrelated stuff and they told me the lower ball joints were bad on my truck. I suspected something to that effect as I was getting the jumping around in the wheel and driving when I hit a pot hole or bump.
They didn't mention the upper ball joint on the control arm but since I have the entire thing tore apart anyway would you just go ahead and replace it? I have to replace the entire control arm if I do. It doesn't look horrible that I can tell but I ain't the best at diagnosing shit. If I watch some videos though I am great at tearing shit apart and putting back together. I just don't want to have to do this again anytime soon. What say you? |
Control arms are kind of pricey and there's less stress on the upper joint than the lower. I, personally, wouldn't change the upper/control arm unless there is actually wear. They dont' tend to wear anywhere near as fast as the lowers. I'd have them check the control arm bushings as well though just to be sure. If all looks good, do just the lowers and maybe outer tie rod ends.
|
Quote:
|
Quote:
|
I read my wife your post and her response was the exact same as mine ROFL
I'm on the road right now but will explain when I get home. |
04 could have a couple different suspensions. Does yours have struts?
|
Does the truck squeak when going over a bump or particularly rough patch of road? That'd indicate, more often than not, bad bushings. I had a slammed 88 s10 when I was younger and I currently have a lowered STI swapped 04 Forester. I'm pretty harsh on my suspensions. Each component gives you a unique feel and sometimes sound as they go..
|
My Grand Cherokee has been doing that twitchy thing as well when I hit a bump or dip in the road, been wondering what the hell is causing that. Sucks if it is the ball joints/control arms because that's not a repair I'm going to take on myself.
|
Quote:
|
Quote:
|
Quote:
|
Quote:
Ball joints will squeal very often. Much more likely than bushings |
Quote:
You recommended not changing the uppers because they weren't bad but then recommended replacement of the outer tie rod ends just out of the blue. That really mate no sense to me. |
And any one with a 5.4 3 valve hit me up when it goes. I install tons of them.
|
Squeal or squeak? There's a distinct difference. I've destroyed enough bushings to know the difference. The bushings will constantly squeak as if you're bouncing on an old metal framed bed.
|
All times are GMT -6. The time now is 12:57 AM. |
Powered by vBulletin® Version 3.8.8
Copyright ©2000 - 2024, vBulletin Solutions, Inc.